Hoshizaki FM-1000ASFE3 Manual De Instalación página 2

1. In order to carry out safe and proper installation
of the product, please read this booklet
carefully beforehand and follow the instructions
contained within.
2. On completion of the installation, start up the
icemaker to check for any abnormalities, and
instruct the user on how to use and maintain
the icemaker in accordance with the
Instruction Manual.
3. This booklet should be handed over to the user
after the installation and be preserved by the
user together with the Instruction Manual for
any further consultation that may be
necessary.
The installation must be carried out by
qualified personnel, in accordance with current
regulations, according to the manufacturer's
instructions.
1. UNPACKING
Children should not be allowed in reach of the
packaging elements (plastic bags and expanded
polystyrene) as they are potential sources of
danger.
Remove shipping carton, tape(s) and packing. If
packing material is left in the icemaker, it will not
work properly.
Note: 1. This icemaker needs a Storage Bin. The
recommended Storage Bin is HOSHIZAKI
ICE STORAGE BIN, Model B-500SD(PD),
B-700SD(PD) with Top Kit - 14C, or B-
900SD(PD) with Top Kit - 22C.
2. This icemaker requires HOSHIZAKI
CONDENSER UNIT, Model URC-20FE.
1) After removing the packaging, make sure that the
icemaker and the Storage Bin are in good condition.
If in doubt, please do not use the equipment but
apply to professionally qualified personnel. See the
instruction sheet attached to the Storage Bin for its
unpacking and installation guidelines.
92E2DA20E0303
IMPORTANT
WARNING
WARNING
CAUTION
2) Remove the shipping tape holding the Front Panel.
3) Remove the Front, Top and Side Panels. See Fig.
1.
Front Panel
Front Panel: Remove the screw. Lift up and
pull toward you.
Top Panel: Remove the screw. Lift up front,
push away, and then lift off.
Side Panel: Remove the screw. Pull slightly
toward you, and lift off.
4) Remove the package of accessories, and check
the contents:
a) Installation Kit
Inlet Hose
Outlet Hose
b) Scoop
c) Mounting Bracket
d) Bolt
5) Remove the protective plastic film from the panels.
If the icemaker is exposed to the sun or to heat,
remove the film after the icemaker cools.
2. LOCATION
IMPORTANT
1. This icemaker is not intended for outdoor use.
Normal operating ambient temperature should
be within 5°C to 40°C. Normal operating water
temperature should be within 5°C to 35°C.
Operation of the icemaker, for extended
periods, outside of these normal temperature
ranges may affect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm clearance at rear and sides for
proper air circulation and ease of maintenance
1
ENGLISH
Top Panel
Side Panel
Fig. 1
1
2
1
2
2