Error Codes; Corrective Action - Stanley TLM30 Manual Del Usuario

Error Codes

E
Code
--- Received Signal Too Weak or
Measuring Time Too Long
--- Received Signal Too High
--- Too Much Background Light
--- Laser Beam Interrupted
--- Insufficient Battery
301 Temperature Too High
Temperature Too Low
401 Hardware Error
6
Description

Corrective Action

Use a target plate or change the target surface.
The target is too reflective. Use a target plate or change the
target surface.
Reduce the background light on the target area.
Remove any obstacles in the path of the laser beam and repeat
the measurement.
Recharge the tool's battery.
Allow the tool to cool down to a temperature within the specified
Operating Temperature Range.
Allow the tool to warm up to a temperature within the specified
Operating Temperature Range.
Switch the tool on and off several times. If the hardware error
still does not clear, return it to a Service Center or distributor.