Rules For Safe Driving - Peg-Perego MINI RACER Empleo Y Manutencion

Ocultar thumbs Ver también para MINI RACER:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
figure.
14 • Insert the whole unit into the rear of the vehicle
(gear motor side), engaging the gear motor
pentagon into the bush as shown in the figure.
15 • Fully insert the large rounded bush inside the
remaining wheel.
16 • Insert a washer and the remaining wheel onto
the other end of the axle.
17 • Position the conical tool, which was used
previously, on the axle (gear motor side). Taking
care that the tool does not move, turn the
vehicle onto the gear motor side. Insert a self
locking washer into the remaining tool
provided and attach the wheel (see figure).
18 • Turn the vehicle back onto its wheels and fit
the four boss cover caps, making sure the teeth
engage into the respective cavities.
19 • Fit the front plate, applying pressure to snap it
into its slots in the bodywork.
20 • Apply transfers A and B to the front plate.
21 • Press the front lights to snap them into place.
22 • Insert the windscreen into its three slots.
23 • Fasten the windscreen at the sides with the two
screws.
24 • Connect the steering wheel and dashboard
plugs as shown in the figure. Insert the
connected plugs under the steering wheel (see
detail A).
25 • Insert the steering wheel onto the steering
shaft, aligning the holes in the two elements.
26 • Fasten the steering wheel with the screw and
nut provided. IMPORTANT: the nut must be
inserted into the hexagonal hole and the screw
into the round hole.
27 • Connect the plug of the electrical system to the
battery plug.
28 • Position the seat support, engaging first the
two rear tabs (1) and then the two front tabs
(2).
29 • Put the seat in the required position by
inserting the two front tabs and then engaging
the rear tab (detail A). Important: the seat can
be set in three different positions according to
the height of the child.
30 • Fasten the seat with the screw.
31 • Insert the roll-bar into its slots.
32 • Fasten the roll-bar with the four screws
provided.
VEHICLE FEATURES AND INSTRUCTIONS FOR USE
33 • ELECTRONIC STEERING WHEEL: the steering
wheel has two drive buttons (A forward, B
reverse). The two orange buttons (C) with LEDs
start eight melodies and if pushed together
produce three sounds (engine roar, horn, and
braking).
• STOPPING SYSTEM: when the drive buttons on
the steering wheel are released, the vehicle
stops automatically.
34 • The seat can be set in three different positions
depending on the height of the child.
REPLACING THE BATTERY
35 • Remove the screw behind the seat. Push the
seat locking tab to release it and allow access
to the battery compartment.
36 • Unscrew the battery holder and remove it.
37 • Disconnect the plugs by pressing them on the
sides.
• Remove and replace the battery. Reconnect the
plugs and screw the battery holder back on.
Close the seat and replace the retention screw.
BATTERY RECHARGE
WARNING: BATTERY CHARGING AND EVERY OTHER
OPERATION ON THE ELECTRICAL SYSTEM MUST BE
CARRIED OUT BY ADULTS ONLY.
THE BATTERY CAN ALSO BE CHARGED WITHOUT
REMOVING IT FROM THE TOY.
• Disconnect plug A of the electrical system from
the battery plug B by pressing the sides.
38 • Connect the battery charger plug into a
domestic power supply as per the attached
instructions. Connect plug B with plug C of the
battery charger.
• When charging is complete, detach the battery
charger from the domestic supply and then
disconnect plug C from plug B.
39 • Fully insert plug B into plug A until it engages
with a click. On completion always remember
to refit the battery holder (if the battery has
been removed), close the battery
compartment, and refit the seat with the
retention screw.
BATTERY MAINTENANCE AND SAFETY
Before riding, charge your batteries for 18 hours to
initiate them. Failure to do this will result in
permanent battery damage.
CAUTION
Only adults should recharge batteries,never
children.
Never allow children to handle batteries.
Do not mix old and new batteries.
CHARGE BATTERY
• Charge the batteries no longer than 24 hours,
following the instructions enclosed with the
battery charger.
• Charge the battery, as the vehicle shows low
power, in this way you will avoid damage to the
battery.
• If you don't use your vehicle for a long period of
time unplug the battery from the main wire
harness of the vehicle. Remember to charge the
battery at least every three months.
• Never charge the battery upside down.
• Do not forget batteries during charging! Check
them periodically.
• Never use a replacement recharger or batteries
unless they are approved by PEG PEREGO.
• Batteries are sealed and maintenance free.
• Battery polarity must be observed when
connecting battery to wiring.
WARNING
• BATTERIES CONTAIN TOXIC AND CORROSIVE
SUBSTANCES. DO NOT TAMPER WITH THEM.
• Batteries contain an acid-based electrolyte.
• Do not make direct contact between battery
terminals, as this can cause an explosion or fire.
• Charging produces explosive gases. Charge
batteries in a well ventilated area away from
sources of heat and flammable materials.
• Exhausted batteries are to be removed from the
vehicle.
• Do not place the batteries near clothing to avoid
damage.
• Use only the recommended type of batteries and
storage batteries, or the equivalent.
IF A LEAK DEVELOPS
Shield your eyes. Avoid direct contact with the
electrolyte, protect your hands.
Place battery in a plastic bag and follow directions
listed below.
IF ELECTROLYTE COMES IN CONTAC WITH SKIN OR
CLOTHING
Flush with cool water for at least 15 minutes.
See a physician at once.
IF ELECTROLYTE IS INJESTED
Rinse your mouth and spit.
See a physician at once.
DISPOSAL OF BATTERIES
Help protect the environment!
Do not throw used batteries in your regular, house
hold trash.
Dispose of the old batteries in an approved
dumping station; contact your local environmental
protection agency office for further information.
VEHICLE MAINTENANCE AND SAFETY
This product complies with European Safety
Standards for toys. It does not comply with
standards for road transport and therefore cannot
be used on public roads.
MAINTENANCE AND CARE
• Regularly check the conditions of the vehicle,
particularly the electrical system, the plug
connections, the covering caps and the charger. In
case of fault, do not try to use the vehicle and the
charger. For repair use only original PEG PEREGO's
spare parts.
• PEG PEREGO assumes no liability if the electrical
system is tampered with.
• Do not leave vehicle or batteries near sources of
heat such as radiators, stoves, fireplaces, etc.
• Protect vehicle from water, rain, snow, etc. Do not
ride in loose sand or mud as these substances will
cause premature failure of switches, motors and
gears.
• When operating in overload conditions, such as
soft deep sand, mud or rough uneven terrain, the
overload circuit breaker will automatically
disconnect the power. After 10 or more
seconds,the circuit breaker will automatically
reset, howevere you must eliminate overload
conditions to resume normal driving.
• Periodically lubricate (with a light weight oil)
moving parts, such as wheel bearings, steering
linkages, where they rotate or touch one another.
• The vehicle's surface can be cleaned with a
dampcloth. Do not use abrasive cleaners.
• The cleaning must be carried out by adults only.
• Never disassemble the vehicles mechanisms or
motors unless authorized by PEG PEREGO.
Recargeable battery 6V 4,5Ah sealed lead-acid battery.
One 60W motor
WEEE DIRECTIVE (EU only)
• At the end of its useful life, this product is classed
as Waste Electrical and Electronic Equipment
(WEEE) and must therefore not be disposed of as
urban waste but instead must be taken to a
designated separated waste collection facility.
• Take the refuse to the relevant designated
collection facility.
• The presence of dangerous substances contained
in the electrical components of this product
represents a potential source of danger for human
health and for the environment if the product is
not correctly disposed of.
• The barred dustbin indicates that the product
must be subject to sorted waste collection.
SAFETY
WARNING! THE CAR MUST BE USED UNDER ADULT
SUPERVISION.
• A child must be 2 years of age or older for the
necessary coordination and maturation to operate
this motorized vehicle safely.
• Never use the vehicle on steep slopes or near
steps or stairs. This vehicle is not suitable for use
on public highways.
• Children should always wear shoes when riding in
or driving a ride-in/ride-on vehicle.
• Do not allow children to place their hands, feet or
any part of their body, clothing or other articles
near the moving parts while vehicle is in
operation.
• Do not allow the electrical components, motors,
wiring, switches of your motorized vehicle to
become wet and never wash it with a hose.
• Never use gasoline or other flammable
substances near the vehicle.
• The vehicle is constructed just for one child.

RULES FOR SAFE DRIVING

DON'T STOP THE FUN: always have freshly charged,
back-up batteries on hand.
For your child's safety: please read and follow all
instructions below before operating.
• ATTENTION:
Make sure that all locking bolts are correctly
tightened.
• FORWARD DRIVE:
Press the round button on the right of the
steering wheel. The vehicle starts moving forward
at a speed of approximately 4 Km/h - 2,5 mph.
• REVERSE:
Press the round button on the left of the steering
wheel. The vehicle starts moving in reverse at a
speed of approximately 4 Km/h - 2,5 mph.
• STOPPING:
When the drive buttons on the steering wheel are
released, the vehicle stops automatically.
Teach your child the proper use of this vehicle for a
safe and fun play time.
• Before starting be sure that the way is free from
people and objects.
• Drive with both hands on the handlebar and keep
your eyes on the road at all times.
• Stop in time to avoid accidents.
• CAUTION! When operating in overload
conditions, such as soft deep sand, mud or
rough uneven terrain, the overload circuit
breaker will automatically disconnect the
power. After 10 or more seconds,the circuit
breaker will automatically reset, howevere you
must eliminate overload conditions to resume
normal driving.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Iged1100

Tabla de contenido