Zodiac CADET ROLL UP 200 Manual Del Propietário página 24

1. Deflate the boat.
2. Replace the valve protections.
3. Remove oars and equipment.
4. Remove the floorboard (For Cadets solid only - for cadets Roll up with a slatted floor, It is not
necessary to remove the slats to fold the boat).
5. Empty the boat of all water and sand by opening the self-bailers, dry it.
6. Fold in the 2 sides of the main buoyancy tube (A), fold the cones onto the transom, then
the boat around the transom (C). Start again if you feel there is still some air left in the tubes.
buoyancy tube
tube deflated
Stow the boat in its bag as follows (D):
. Stow the boat folded on its bag open (back side of the bag visible).
. Position the floor sections and stringers flat on the boat (Cadet Solid), then the oars
dismantled.
. Close the bag and fasten the two front straps.
. Tight the side ropes (make sure that all equipment stays inside).
. To finish, store the foot-pump in the front pocket.
DEFLATING / FOLDING THE BOAT
A
floor
C
D
/ 10
10
roll up
B