Dryer Exhaust Requirements; Exhaust System Materials - Alliance Laundry Systems D009C Instalación/Operación

Installation

Dryer Exhaust Requirements

WARNING
A clothes dryer produces combustible
lint. To reduce the risk of fire and
combustion gas accumulation the dryer
MUST be exhausted to the outdoors.
This gas appliance contains or produces
a chemical or chemicals which can cause
death or serious illness and which are
known to the State of California to cause
cancer, birth defects, or other
reproductive harm. To reduce the risk
from substances in the fuel or from fuel
combustion, make sure this appliance is
installed, operated, and maintained
according to the instructions in this
manual.
To reduce the risk of fire and the
accumulation of combustion gases, DO
NOT exhaust dryer air into a window well,
gas vent, chimney or enclosed,
unventilated area, such as an attic, wall,
ceiling, crawl space under a building or
concealed space of a building.
To reduce the risk of fire, DO NOT use
plastic or thin foil ducting to exhaust the
dryer.

Exhaust System Materials

Exhaust system materials are not supplied with the
dryer unit.
Exhaust duct must be four inches (10.2 cm) in
diameter having no obstructions. Rigid metal duct is
recommended. Non-combustible flexible metal duct is
acceptable. Do not use plastic or thin foil ducting,
because it contributes to poor drying performance and
collects lint, which can lead to a fire hazard.
Never install flexible duct in concealed spaces, such as
a wall or ceiling.
34
W116
W115
W045
W354
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
DO NOT use sheet metal screws on exhaust pipe joints
or other fastening means which extend into the duct
that could catch lint and reduce the efficiency of the
exhaust system. Secure all duct joints with duct tape or
pop-rivets.
Description
Exhaust Duct (4" Dia.)
Flexible Metal Duct
(4" Dia.)
Weather Hoods, with
hinged dampers (4")
Directional Exhaust
Kit
Tape
NOTE: Kits described above are optional exhaust
system materials available at extra cost.
.
DO
D354I
Figure 22
May Be
Kit P/N Obtained
Locally
Not Available Yes
521P3 Yes
Not Available Yes
528P3 No
Not Available Yes
DON'T
D356I
510975