Before You Start; Tools; Gas; Location - Alliance Laundry Systems D009C Instalación/Operación

Before You Start

Tools

For most installations, the basic tools you will need
are:
1
1 Wrench
2 Screwdrivers
3 Level
4 Teflon Tape
5 Duct Tape
Figure 3

Gas

Dryer is equipped for Natural Gas with a 3/8" N.P.T.
gas supply connection. For more detailed information,
refer to section on Gas Requirements.

Location

Place the dryer on a solid floor with an adequate air
supply. For more detailed information, refer to section
on Location Requirements.
510975
2
3
5
4
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT

Exhaust

Use rigid metal duct and exhaust the dryer to the
outside by the shortest route possible.
D818I
NOTE: For more detailed information, refer to
section on Dryer Exhaust Requirements.

Electrical

ELECTRIC DRYER

G
Dryer needs a 3 or 4 wire 120/240 or
120/208 Volt, 60 Hertz, 30 Amp, AC single
phase electrical supply for each unit.

GAS DRYER

G
Dryer needs a 120 Volt, 60 Hertz, 15 Amp,
polarized 3-slot effectively grounded receptacle
for each unit.
NOTE: For more detailed information, refer to
section on Electrical Requirements.
Installation
Figure 4
D354I
13