Adjustment Of Flat Panel Screen - PEERLESS SA761P Manual Del Usuario

Adjustment of Flat Panel Screen

• M10 x 15 mm screws (E) must be securly tightened before changing orientation of wall arm assembly (A). Failure to
lock adapter bracket can cause screen to come off of mount.
FOR PORTRAIT OR LANDSCAPE SCREEN ORIENTATION: Remove two M5 x 12 mm screws and rotation block
5
from top of tilt head as shown in top view and rear view. Gently grasp sides of screen and rotate screen into portrait
or landscape position as shown in figure 5.1 then reinstall rotation block with two M5 x 12 screws.
TILT Adjustment: Adjust tension knob on side of
6
mount to desired tension to enable tilt adjustment
and balance your screen size and weight. Push or
pull from top or bottom of screen to adjust tilt as
shown. The tilt can be adjusted to a maximum of 10°
forward or 5° backward. Retighten tension knob.
ROLL Adjustment: Rotate screen 5° clockwise or
counter-clockwise, level screen then tighten
M5 x 10 mm screws as shown in detail 2.
FOR VERTICAL HEIGHT ADJUSTMENT: Tighten
or loosen M8 x 40 mm screws to achieve ± 1" of
vertical height adjustment as shown in detail 2.
NOTE: M8 x 40 mm screws must be turned an
equal number of times.
CAUTION
• Do not tighten screws with excessive force.
• Be careful not to pinch fingers when opening and
closing mount from the wall.
WARNING
ROTATION BLOCK
M5 x 12 MM SCREWS
TOP VIEW
M5 x 12 MM SCREWS
ROTATION BLOCK
REAR VIEW
8 of 32
fig. 5.1
TENSION
KNOB
M5 x 10 MM SCREWS
M8 x 40 MM
DETAIL 2
SCREWS
ISSUED: 03-30-10 SHEET #: 095-9346-1