Replacement- And Wear Parts; Warranty And Liability - Hach PHOSPHAX sigma Manual Básico Del Usuario

Replacement- and wear parts

Item no. Designation
LZP993 Springs (4 pieces for cuvette contact pressure)
LZP871 Filter pad (air filter)
LQV083 Refrigerator
LZP856 Cuvette
LZP991 Cuvette cover front
LZP989 Fan
LZP777 Pump cassette
LZP872 / LZP873 Set of pump rollers (8 pieces) one-channel / two-channel
LZP850 / LZP849 Pump head one-channel / two-channel
LZP854 Hose pinch valve, 3/2-way
LZP990 Hose holder (hose pinch valve)
Screw cap including suction line for 500 mL bottle
LZP986
(standard solution)
Screw cap including suction line for 5 L canister
LZP987
(reagents)
YAA910 Moisture sensor plate
LZP859 Safety valve (without upper cuvette holder)
LZP868 Safety panel complete
LZV128 Door lock
LZP847 Valve piston
BLS075 Valve hose
LZP858 Valve membrane + anchor (safety valve)
LXV231 / LXV232 /
SIGMATAX 2 – connection hose 10 m / 20 m / 30 m
LXV282
LXV215 SIGMATAX2 – control unit
LZX408 VIEWTAX program
English 112

Warranty and liability

The manufacturer warrants that the supplied product is free of material
and manufacturing defects and undertakes to repair or replace any
defective parts at zero cost to the owner.
The guarantee period for devices is 24 months. Upon conclusion of a
maintenance contract within the first 6 months after purchase, the
guarantee period extends to 60 months.
For defects to which the lack of assured properties also counts, the
supplier is liable with exclusion of further claims as follows: All those
parts that, within the guarantee period calculated from the day of the risk
transfer, can be demonstrated as a result of circumstances prior to the
risk transfer, in particular due to defective design, inferior materials or
defective execution, to be unusable or whose usability is significantly
impaired, are improved or replaced in accordance with the choice of the
supplier free of charge. The identification of such defects must be
notified to the supplier immediately, however at the latest seven days
after the identification of the fault, in writing. If the customer omits this
notification, the performance is considered approved despite the defect.
Further liability for any direct or indirect damages is not accepted.
If instrument-specific maintenance and servicing work prescribed by the
supplier is to be performed within the warranty period by the customer
(maintenance) or by the supplier (servicing) and these requirements are
not met, claims for damages resulting from non-compliance with these
requirements are rendered void.
Any further claims, in particular claims for consequential damages,
cannot be made.
Wear and damage caused by improper handling, incorrect installation or
non-designated use are excluded from this clause.