Kolcraft travel about Manual De Instrucciones página 4

1 & 2
Tab locks into hole
4
5
6
To Assemble Rear Wheels
4
Turn stroller over as shown.
1
Position rear axle assemblies as shown,
2
with red brake levers pointing towards
stroller handle.
Push rear axle assemblies onto rear leg
3
tubes at the same time.
Make sure plastic tabs on rear axle lock
4
into holes on rear legs as shown.
Slide a wheel onto the axle than slide a
5
washer onto the axle.
Fit straight part of cotter pin through
6
hole on axle as shown.
Line up each of the tabs in the hub cap
7
with the slots in the wheel, snap hub cap
into place.
Repeat for second side.
8