Bottom; Drawer Bottom; Drawer Front; Back - Sauder Pinwheel 421885 Manual Del Usuario

Step 8
1
D14
F
Groove
Insert the DRAWER SIDES (D14 and D15) at an angle
å
into the slot at each end of the DRAWER FRONT (F).
3
Be sure the
DRAWER
BOTTOM inserts
into the DRAWER
BACK groove.
Fasten the DRAWER BACK (D162) to the DRAWER SIDES (D14 and D15).
å
Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D719) inserts into the groove of
å
the DRAWER BACK (D162).
Page 12
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D162
D14
D719
VIEW THE T-LOCK BOX VIDEO
2
U n
fi n
s u
r f a
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D719) into the grooves in the
å
DRAWER SIDES (D14 and D15) and DRAWER FRONT (F).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
421885
With the palm of your hand,
tap the DRAWER BOTTOM
down into the groove.
i s h
e d
c e
D719
D15
F
30S
(4 used in this step)
www.sauder.com/services