How To Enable Charging With Your Rfid Card; Applies Only To Evr30-R2C - Leviton evr-green EVR30-B1C Guia De Instalacion

How to Enable Charging
With Your RFID Card

Applies only to EVR30-R2C

1.
Enable charging.
TAP your RFID card to the front of
the charger over the image of the
RFID. The POWER light will flash
green quickly when the RFID card
has enabled the unit to charge.
2.
Start charging.
Press and hold the black button on
the top of the charge plug and insert
it into the inlet on your car. Charging
starts automatically. The CHARGE
light will flash green.
3.
How to stop and restart.
To stop charging, press black button
on top of charge plug to remove
plug. To restart charging, tap your
RFID card, press black button and
reinsert.
4.
After charging is complete.
NOTE: When charging is complete,
loop charging cable over station to
prevent tripping hazard.
NOTE: If the charging station is not
being used for an extended period of
time, it should be turned off.
POWER
CHARGE
FAULT
POWER
CHARGE
FAULT
14
Button
Button