Bosch RotoZip RZ5 Instrucciones De Funcionamiento Y Seguridad página 10

BUMP-OFF SLIDE "ON/OFF" SWITCH
This tool is switched "ON" by the slide switch
located on the front of the motor housing
(Fig. 6).
TO TURN THE TOOL "ON" slide the switch
button up.
TO TURN THE TOOL "OFF" slide the switch
button down or "0" position.
Hold the tool with both hands
WARNING
!
while starting, since torque
from the motor can cause the tool to twist.
FIG. 6
BUMP-OFF SLIDE
"ON/OFF" SWITCH
1
0
ELECTRONIC
VARIABLE SPEED CONTROL
(Models RZ10 & RZ20 only)
The electronic speed control feature allows
motor speed to be matched to cutter size and
material hardness for improved finish,
extended bit life, and higher performance.
Speed changes are achieved by rotating
DEPTH GUIDE ADJUSTMENT
Use the depth guide to adjust the depth of
cut. Using the end of the standard wrench,
loosen (counter clockwise) the screw enough
to enable the depth guide to slide up or down
to the desired depth of cut (about 1/8"
greater than material thickness) and
retighten the locking screw (clockwise)
(Fig. 8).
WORKLIGHT (Model RZ20 only)
Your tool is also equipped with a light that
turns on automatically when the switch is
Operating Instructions
Control Dial RIGHT to increase speed, LEFT
to decrease as indicated on housing (Fig. 7).
Speed may be changed while tool is on. The
reference numbers on the dial facilitate
re-setting control to desired speed.
VARIABLE SPEED CONTROL DIAL
FIG. 7
For best results, when using RZ bits, we
recommend only using dial setting 25 or 30.
You will not obtain a quality cut if you lower
the dial setting to 15 or 20.
DIAL
SETTING
15
20
25
30
DEPTH GUIDE
LOCKING
SCREW
activated, for better visibility when cutting
(Fig. 1).
-10-
(Models RZ10 & RZ20 only)
APPLICATION
Not Recommended
Not Recommended
All Materials
All Materials
1/8"
FIG. 8