Bosch RotoZip RZ5 Instrucciones De Funcionamiento Y Seguridad página 4

Always hold the tool with two hands
during start-up. The reaction torque of the
motor can cause the tool to twist.
When routing or cutting, the direction of
feed with the bit's cutting edge into the
material is very important. Always feed
the bit into the material in the same
direction as the cutting edge is exiting
from the material. When viewing the tool
from the top, the bit rotates clockwise. If the
tool is between the workpiece and you body,
then feed the tool to your right. If the
workpiece is between the tool and your body,
then feed the tool to your left. Feeding the
tool in the wrong direction causes the cutting
edge of the bit to climb out of the work and
pull the tool in the direction of this feed.
START
HERE
WORK
BIT
Never use dull or damaged bits. Sharp
bits must be handled with care. Damaged
bits can snap during use. Dull bits require
more force to push the tool, possibly causing
the bit to break.
Never touch the bit during or immediately
after the use. After use the bit is too hot to
be touched by bare hands.
Zipmate Abrasive Cut-Off Attachment Safety Rules
Always use wheel guard, and the tool's
auxiliary handle with this abrasive cut off
tool. The guard must always be securely
attached to the tool and positioned for
maximum safety, so the least amount of
wheel is exposed on the operators side of
the tool. A guard protects operator from
broken wheel fragments. The support ribs
and auxiliary handle provide additional
guarding, stability and control in cut off
applications. The body of your Rotozip tool
Never lay the tool down until the motor
has come to a complete standstill. The
spinning bit can grab the surface and pull the
tool out of your control.
Never use bits that have a cutting
diameter greater than the opening in the
base.
Do not use the tool for drilling purposes.
This tool is not intended to be used with drill
bits.
Always use the tool with the depth guide
securely attached and positioned flat
against material being cut. The guide
securely positioned on the material improves
the stability and control of your tool.
WARNING
!
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
DIRECTION OF
FEED
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specially
designed to filter out microscopic particles.
or your Zipmate attachment can also be
used as a handle.
Always be certain that the wheel guard,
and
reassembled and securely fastened to the
tool when changing the point of operation
from fire forward to fire reverse or after
changing the wheels. A tool missing an
essential safety component is dangerous to
operate.
-4-
Some dust created by
power sanding, sawing,
tool's auxiliary handle are