Bosch RotoZip RZ5 Instrucciones De Funcionamiento Y Seguridad página 9

Disconnect the plug from
WARNING
!
the power source before
making any assembly, adjustments or
changing accessories. Such preventive
safety measures reduce the risk of starting
the tool accidentally. Make certain that the
collet nut is securely tightened before turning
the tool on.
REMOVING AND INSTALLING THE
DEPTH GUIDE ASSEMBLY
The depth guide assembly consists of the
depth guide, locking screw and bracket.
In order to remove the depth guide from the
tool, release the locking lever and pull the
entire assembly straight off of the tool. To
reattach the assembly, fully replace the guide
INSTALLING BITS
The bits are held by a keyless collet system
designed specifically for spiral saw bits with
1/8" (.125"), 1/4" (.250") or 5/32" (.156") shanks.
The bit flutes are sharp and
WARNING
!
should be handled with
caution.
Depress and hold the shaft-lock in and rotate
the keyless chuck and shaft until the shaft-
lock engages and holds the shaft.
To prevent damage to tool.
CAUTION
!
Never use the shaft lock as a
braking devise to stop the tool from rotating.
Rotate the keyless chuck (counter-clockwise)
(Fig. 2). Remove the old bit (if there is one)
insert the new bit as far as possible, but not
so far that the bit flutes engage the jaws of
the chuck (leave approximately 1/8" of shank
REMOVING AND INSTALLING THE HARD
AUXILIARY CONTROL HANDLE
Turn the tool OFF and unplug it. Firmly
grasp the tool. Lift open handle release
button cover, depress release button and
remove handle (Fig. 3).
Gently engage the two (2) front latches on
handle into the tool and push handle until it
snaps securely into place.
Assembly
onto the tool collar and lock the clamp lever
(Fig. 1).
REMOVING AND INSTALLING THE
DUST HOOD ASSEMBLY
(Not included, available as accessory)
The dust hood is sized to accept 35mm
vacuum hoses.
The dust hood assembly consists of the dust
hood, locking knob and bracket.
In order to remove the dust hood assembly
from the tool, release the locking lever and
pull the entire assembly straight off of the
tool. To reattach the assembly, fully replace
the guide onto the tool collar and lock the
clamp lever (Fig. 1).
exposed) Re-engage the shaft-lock and
securely tighten the keyless chuck
(clockwise) by hand.
Note: When using 1/4" and 5/32" bits it may
be necessary to use a wrench on the front of
the keyless chuck to securely tighten the bit.
FIG. 2
SHAFT
LOCK
-9-
1/8"
KEYLESS
CHUCK
FIG. 3
HANDLE
RELEASE
BUTTON
COVER
HANDLE
RELEASE
BUTTON