Bluetooth Audio - Lenco PDR-035 Manual De Usuario

Audio Setting
1. Press and hold the INFO/MENU button to access the menu control.
2. Rotate the ENTER knob (or press the
3. Rotate the ENTER knob (or press the
ENTER knob to confirm.
4.
To quit the menu control, press the BACK button repeatedly.

BLUETOOTH AUDIO

Please follow the pairing instructions below to link the unit to your Bluetooth device.
1. Press the SOURCE button to enter the Bluetooth mode. The display will show "Disconnected". It will start searching.
2. Turn on the Bluetooth function of your device and enable the search until "Lenco PDR-035" is found. Select "Lenco PDR-035" on
the Bluetooth device to make connection. Enter the pass code "0000" if required.
3. After successfully paired the display will show "Bluetooth Connected".
4. You can now start playing music from your smartphone wirelessly to the speaker.
5. You can press the
6. You can press the
Note:
● Press and hold the UNPAIR button will disconnect the connection and start to search another new Bluetooth device.
● Due to ErP stage 2 requirement and protect the environment, the unit will turn off in standby mode automatically once no
music has been playing for around 15 minutes in Bluetooth mode. When the unit is power off due to ErP, press and hold the
STANDBY button to turn on the unit again.
"This product has a bluetooth reception function, you cannot transmit any bluetooth sound with it: this means that the Lenco PDR -
035 can only receive a bluetooth sound signal from an external source like a smartphone/tablet."
AUX IN
This allows you to connect an external player's sound through your unit.
1. You need to plug in a 3.5mm audio cable (not included) first into the unit's AUX IN terminal.
2. Press the SOURCE button to enter the AUX IN mode.
3. Start your external player to play music.
4. The unit will output the sound.
Note:
● Due to ErP stage 2 requirement and protect the environment, the unit will turn off in standby mode automatically when it is in
AUX mode for more than 4 hours. 10 minutes before entering the standby mode you will be notified with "AUTO POWER OFF"
on the display. To extend the AUX mode you can press the
the STANDBY button to turn on the unit again.
or
or
button to pause or resume the playback.
or button to skip to the previous or next song.
button) until the "Audio Setting" is selected and then press the ENTER knob.
button) until to select "Stereo Allowed" or "Forced Mono" and then press the
button. When the unit is power off due to ErP, press and hold
9