Tripp-Lite SNMPWEBCARD Manual De Instalación página 2

Installation
Warning: When handling the SNMPWEBCARD, follow standard ESD (electrostatic
discharge) precautions to avoid damaging the card. For your safety, you should also
read the documentation that came with your UPS system or PDU to familiarize
yourself with precautions against electric shock.
The SNMPWEBCARD allows users to operate any compatible Tripp Lite UPS
System or network-enabled PDU as a managed device on the network,
accessible via Web browser, Network Management Station or telnet/SSH.
This manual refers to installing the card in a UPS system, but the same
instructions apply to installing the card in a compatible PDU.
1 - Preparation
Confirm Package Contents: In addition to this manual, your package
1-1
should include the accessory card in an anti-static bag, a configuration
cable (73-1025), several faceplates and a CD-ROM containing
additional documentation and Management Information Base (MIB)
files for use with Network Management Systems (not otherwise
required). If anything is missing, contact your supplier immediately.
Note for Network Management System Users Only: Two MIB files -
Tripplite.mib and RFC1628.mib - must be loaded on each Network
Management Station that will monitor the UPS system via SNMP . The
files are provided on the CD-ROM included in the product package.
Install UPS: Install your UPS system and turn it on before installing the
1-2
SNMPWEBCARD. Ensure that the accessory card slot is accessible.
Locate MAC Address: The 12-digit MAC address (000667xxxxxx) is
1-3
printed in two locations: a label attached to the underside of the card
and a duplicate label inside the box. Attach the duplicate label to the
UPS system or keep it in a secure location for easy reference.
13-01-199-933179.indb 2
2
4/23/2013 4:01:48 PM