Tripp-Lite SNMPWEBCARD Manual De Instalación página 47

Installation
HARDWARE PARAMETERS:
Serial channels will use a baud rate of 9600
RTC date and time in GMT: 03/13/2012 18:19:51
This board's serial number is
This board's Ethernet MAC Address is 00:06:67:22:3E:B1
After board is reset, start-up code will wait 5 seconds
------------------------------------------------------------------------
Press any key in 5 seconds to change these settings.
Press A to Accept the settings, or M to Modify?m
Enter the root password: *********
3-5-1
Paramètres du réseau
Suivre les invites pour configurer les paramètres d'adresses IPv4 et IPv6. Le mot de
passe par défaut en mode terminal est TrippLite. Des exemples de paramètres IP sont
présentés — fournir votre propre information IP quand vous configurez votre carte.
PARAMÈTRES DE L'INTERFACE ETHERNET :
Obtain IPv4 settings automatically using DHCP for Ethernet interface?
[Y]
IP address? [10.1.0.165]
Subnet mask? [255.0.0.0]
Gateway address? [10.0.0.1]
Enable DHCPv6 for the Ethernet interface? [Y]
Enable static IPv6 for the Ethernet interface? [N]
IPv6 address? [2001:DB8::1:58:4F43:4849:544C]
Network prefix length? [64]
DNS server? [10.0.0.8]
This card's host name? [poweralert-061033462177]
This card's domain? [tlsoftwaredev.local]
3-5-2
Configuration du service réseau
Les messages-guides suivants configurent les méthodes de connexion que la
SNMPWEBCARD acceptera.
Enable SNTP? [Y]
Enable FTP? [Y]
Port number? [21]
Enable HTTP? [Y]
Port number? [80]
Enable HTTPS? [Y]
Port number? [443]
13-01-199-933179.indb 47
Enable Telnet Menu? [Y]
Port number? [23]
Enable Telnet Programs? [Y]
Port number? [5214]
Enable SSH Menu? [Y]
Port number? [22]
Enable SSH Programs? [Y]
47
Port number? [2112]
Enable SNMP? [Y]
Port number? [161]
Enable SNMPv1? [Y]
Enable SNMPv2c? [Y]
Enable SNMPv3? [Y]
4/23/2013 4:01:57 PM