Tripp-Lite SNMPWEBCARD Manual De Instalación página 4

Installation
3 - Static IP Address Assignment/Terminal Menu Configuration Settings
Determine IP Information: The SNMPWEBCARD can support a single
3-1
static IPv4 address (requires setting the IP address, subnet mask and
gateway) and/or a single IPv6 static address. In addition the
SNMPWEBCARD can support a single static IPv4 or an IPv6 DNS
address that is required to be entered.
Configure Terminal Emulation Program: Open a VT100-compatible
3-2
terminal emulation program (such as the HyperTerminal program
bundled with Microsoft
DB9 serial port. Note: If a DB9 port is not available, a Serial to USB
adapter (sold separately) can be used for configuration. Set the
terminal emulation program to use the COM port
the DB9 serial port. Specify the parameters
required to communicate with the
B
SNMPWEBCARD terminal interface:
If the terminal emulation program supports
multiple emulation modes, you may also
need to specify VT100 emulation
A
13-01-199-933179.indb 4
Windows ) on a computer with an available
® ®
.
C
B
4
that corresponds to
A
Bits per second: 9600
Data bits: 8
Parity: None
Stop bits: 1
Flow control: None
C
4/23/2013 4:01:49 PM