Tripp-Lite SNMPWEBCARD Manual De Instalación página 5

Installation
Connect SNMPWEBCARD to Computer: Before inserting the card
3-3
into the UPS, use the mini-DIN to DB9 serial cable (part number
73-1025) included with the card to connect the card to the computer.
The circular connector
mini-DIN serial port
avoid damaging the pins.) The DB9 connector
the cable connects to the computer's serial port
A
B
Insert SNMPWEBCARD in Accessory Slot: Use a screwdriver to
3-4
remove the accessory slot cover from the UPS. While the UPS is turned
on, align the SNMPWEBCARD with the guides in the accessory slot and
push the card into the slot until the ports are nearly even with the rear
surface of the UPS.
Welcome to Tripp Lite PowerAlert built on Mar 26 2012 14:08:49
BSP version 012.006.060.000.0075 built on Mar 23 2012 16:02:57
Configure SNMPWEBCARD in Terminal Mode: Within 10-15
3-5
seconds, a menu will appear and the boot process will pause for 5
seconds. Press any key within the 5 second pause to enter
Configuration Mode. A prompt will appear asking to (A)ccept settings or
(M)odify changes. Press 'M' to modify changes and then login with the
default root password "TrippLite". Follow the prompts to make
changes.
13-01-199-933179.indb 5
at one end of the cable attaches to the 8-pin
A
on the card. (Align the connector carefully to
B
5
at the other end of
C
.
D
D
C
4/23/2013 4:01:50 PM