Tripp-Lite SNMPWEBCARD Manual De Instalación página 6

Installation
Note:
• If a key is not pressed within the 5 second pause, the boot process will
continue. To make changes through the terminal program after this, a
reboot is required. A reboot can be accomplished in a few ways:
1. Pull the SNMPWEBCARD out of the device, and then reinsert it.
2. Using a small paper clip, press the reset button through the small
hole on the face plate (below the RJ45 network port).
3. During the boot process, press any key. This will prompt for a login
name and then password. Enter the default username,
"localadmin", the default password "localadmin", and then type
"reboot". This will restart the card.
• If you have the terminal program running and do not see the power ON
banner, remove the card and reinsert, or push the reset button.
Welcome to Tripp Lite PowerAlert built on Mar 12 2012 15:06:25
BSP version 012.006.060.000.0075 built on Mar 12 2012 13:41:22
PLATFORM: trippliteSnmpCard9210_H_16_32 16M/32M [Mar 12 2012 13:41:22]
------------------------------------------------------------------------
NETWORK INTERFACE PARAMETERS:
FQDN poweralert-061033462177
The board will obtain IPv4 configuration parameters from the network.
DHCPv6 is enabled on LAN
DNS server is 10.0.0.8
Time is supplied by RTC
Time zone is set to -6:00 from GMT, DST Enabled
SERVICES:
FTP is enabled on port 21
HTTP is enabled on port 80
HTTPS is enabled on port 443
SSH is enabled on port 22
SSH is enabled on port 2112
TELNET is enabled on port 23
TELNET is enabled on port 5214
SNMP is enabled on port 161
SYSLOG is disabled
13-01-199-933179.indb 6
6
4/23/2013 4:01:50 PM