Tripp-Lite SNMPWEBCARD Manual De Instalación página 3

Installation
Address Assignment: If your network's DHCP server will assign a
1-4
dynamic IP address to the SNMPWEBCARD automatically, proceed to
2 - Dynamic IP Address Assignment. If you will assign a static IP
address to the SNMPWEBCARD manually, proceed to 3 - Static IP
Address Assignment. If you are uncertain which method to use,
contact your network administrator for assistance before continuing the
installation process.
2 - Dynamic IP Address Assignment
Insert SNMPWEBCARD in Accessory Slot: Use a screwdriver to
2-1
remove the accessory slot cover from the UPS. While the UPS is turned
on, align the SNMPWEBCARD with the guides in the accessory slot and
push the card into the slot until the ports are nearly even with the rear
surface of the UPS.
Connect SNMPWEBCARD to Network: Connect a standard Ethernet
2-2
patch cable to the RJ-45 Ethernet port on the card. Note: This port
does not support PoE (Power over Ethernet) applications. The card will
attempt to obtain an IP address via DHCP . This may take as long as
several minutes, depending on your network environment.
Discover IP Address: Contact your network administrator to determine
2-3
which IP address has been assigned to the card by the DHCP server.
The card can be identified on the DHCP server by referring to its MAC
address (see Step
period for the IP address, depending on your application. After you
have discovered the IP address, proceed to 4 -Test and Configure.
Note: The DHCP addresss is also displayed during boot-up when
connected to a computer through the configuration cable and a
terminal emulation program. Note: As of firmware version 12.06.006X,
the SNMPWEBCARD supports both IPv4 and IPv6. It is set up by
default to receive a DHCP address for IPv4, IPv6 or both. Receiving
both addresses allows connection to the card by either IPv4 or IPv6
address.
13-01-199-933179.indb 3
). You may wish to request a long-term lease
1-3
3
4/23/2013 4:01:48 PM