Track Mode - Napa CARLYLE ETW12FL Instrucciones De Operación

If this warning appears, the wrench has applied more
than 110% of the torque set in memory.
SELECTING TRACK AND PEAK MODES
At start up either a (P) or (T) will show in the lower right
hand corner of the display depending on the last time the
wrench was used.
Note: Track (T) mode is the factory default.
1. In order to change the mode, press and hold the
button for 2 seconds.
Note: The display will briefly flash the "mode"
screen.
2. Use the Up/Down buttons to toggle
between the Track (T) and Peak Hold (P) modes.
3. Press button four (4) times to exit mode setting.

TRACK MODE

Track Mode: This mode allows the operator to visually monitor the amount of load that is being applied.
Visual and auditory aids assist the operator in maintaining a consistent torque.
After setting the (T) Track mode and assigning a
Memory Pre-Set to use, operator can begin to apply
load to the wrench.
As a load is gradually applied to the wrench, the display
will show the operator the amount of torque on the
fastener.
When 90% of the desired torque is reached, the green
lights will begin to flash and and alarm tone will beep
intermittently.
When 99.5% of the desired torque has been reached,
the alarm will change to a steady tone, and the green
lights will stop flashing and stay on. The red light will
also illuminate.
ETW12FL, ETW14FL, ETW38FL
Flashing green light and intermittent
tone at 90% of desired torque
((...((... ...))...)) ((...((...
Buzzer
Solid green and red light and steady
tone at 99.5% of desired torque
(((((((( ))))))))
Buzzer
8
...)) ...))
Green LED
Reach 90% of Target
Torque
((((((( )))))))
Red LED
Approached Target Torque
Rev. 02/11/13