Silvercrest SRR 3.7 B2 Instrucciones De Servicio página 48

Wet cleaning of the blade unit
The shaving heads 4 of the shaving attachment 5 can be
cleaned with water.
1. Press the release button 6 on the shaving attachment 5, so
that the blade unit 4 opens.
2. Clean the blade unit 4 under running water. Allow the water
to flow through the shaving heads 4 from the inside to the
outside.
3. Allow the parts to dry completely.
4. Close the blade unit 4, so that it clicks into place.
Thorough cleaning of the blade unit
An integrated timer in the device adds up shaving times. After a
shaving period of 30 minutes, the cleaning symbol 13 starts
flashing. It reminds you of the thorough cleaning that you should
regularly perform. If you switch off the device while the cleaning
symbol is flashing, the timer will start counting shaving times
again from the beginning.
1. Press the release button 6 on the shaving attachment 5, so
that the blade unit 4 opens.
2. Figure D: pull the blade unit 4 off the shaving attach-
ment 5 by overextending it.
3. Figure E: carefully turn the locking wheel 17 marked with
arrows against the direction of the arrows, until the holder of
the shaving heads 18 can be lifted off.
4. Clean all parts under running water, and then allow them to
dry completely.
5. Reassemble the blade unit 4.
6. Figure F: carefully turn the locking wheel 17 in the direc-
tion of the arrows, until the holder of the shaving heads 18
can no longer be lifted off.
46
GB