SOMFY Home Motion Sonesse 30 RTS Guia De Instalacion página 6

COMMISSIONING
Programming the RTS transmitter
Switch on the power supply.
Press the UP and DOWN buttons
simultaneously on the RTS transmitter:
the shade moves for a few seconds
and the transmitter is preprogrammed
in the motor
Checking the direction of rotation
Press the RTS transmitter UP button:
a) If the shade is raised, the direction
of rotation is correct: move to the
section entitled «Adjusting the end
limits».
b) If the shade is lowered, the direction
of rotation is incorrect: move to the
next step. Press the RTS transmitter
MY button until the shade jogs: the
direction of rotation has been modified.
Press the RTS transmitter UP button
to check the direction of rotation.
Adjusting the end limits
The limits can be set in any sequence.
1) Press and hold the UP button to
move the shade to the desired up
position.
2) Press the MY and DOWN buttons
simultaneously and release them once
the shade begins to move. The up limit
is memorized.
3) Press the MY button when it
reaches the desired down position.
If necessary adjust the down position,
using the UP or DOWN buttons.
4) Press the MY and UP buttons
simultaneously and release them
when the shade begins to move.
The down limit is memorized.
The shade moves up and will stop at
its upper limit.
5) To confirm the end limits press and
hold the MY button until the shade
jogs.The end limits are recorded.
Recording the RTS transmitter
Press the programming button on
the back of the RTS transmitter until
the motor jogs. The RTS transmitter
address is permanently recorded.
4
a
=
b
=
1
3
5
Copyright © 2009 Somfy SAS. All rights reserved - V0 - 09/2009
2
4