Dolphin Wave Instrucciones De Uso página 15

7. Set each parameter and then scroll down to the next line.
8. Set Navigation Mode and choose either Rectangular 1 (Default),
Rectangular 2, or Shaped.
Rectangular 1- Recommended for pools with parallel walls, and 90º 'L'
shape.
Rectangular 2- as above, in case magnetic interference that cause
curved motion.
Shaped- Recommended for free formed pools.
9. Set Scanning Path and choose either Default, Lines to Right, or Lines
to Left.
Default- Recommended.
Lines to Right / Left- To be used in cases when the pool scan needs to
be limited to one direction or split into two sections.
In order to use this mode, consult your dealer.
10. After setting the Scanning Path, from the Pool Profile screen, scroll
down to the next screen to "Direction Setup" (Figure 13).
Direction Setup
Delay Time
Line Spacing
Reset Pool A profile
select
Figure 13: Second pool profile screen
11. Press Select to enter Direction Setup.
12. To change the Direction Setup, proceed as explained in Manual
Direction Setup, below.
13. Press Select to enter Delay Time.
Setting a Delay Time allows you to delay the start of cleaning
operations by a time factor selected from the MMI screen.
To override the Delay Time instruction, from the Wave screen press
Start.
Pool A Profile
12
180.0
0 h
Medium
back