Operating Guidelines; Maintenance - Dolphin Wave Instrucciones De Uso

4. From the MMI, press "+" or "-" to correct the robot's direction until it
moves exactly along the width of the pool.
"+" = clockwise direction
"-" = counter clockwise direction
5. Once the desired width direction is achieved, press Next.
6. The Robot will turn 90 degrees to the left and move along the length of
the pool.
7. Next, fine tune along the pool's length using "+" or "-", as in step 2
until the robot moves along the pool's length.
8. Once the desired direction is reached, press Next to confirm the end of
the fine tuning procedure.
9. Press HOME to return to the Wave screen and then press Start to
continue the cleaning session.

Operating Guidelines

•
A large-sized swimming pool of approximately 300 square meters requires
approximately 2–3 hours cleaning time. This is the default setting.
•
An Olympic size pool of 1,250 square meters requires approximately 5
hours cleaning time. This is the default setting.

Maintenance

1. Clean and replace filter as needed. When the MMI displays "Filter Bag
Full", you should clean/replace the bag before the next operating cycle.
It is not necessary to stop the Wave in the middle of the cycle when
"Filter Full" indication appears. Clean the filter before the next
cycle.
Non-disposable filter bags can be cleaned in a washing machine.
Under normal working conditions, disposable bags may be used for
about 3 cleaning cycles.
2. Before each operating cycle, clean the robot body, brushes, and driving
belt area and remove foreign objects, rubber bands, hair etc.
3. Once a week clean impeller area:
•
Remove the impeller cover securing screw using a No. 2 Philips screw
driver.
•
Twist counter-clockwise and open the cylinder cover.
•
Remove foreign objects from the impeller.
•
Close the impeller cover and replace the securing screw.
4. Keep the electrical cable orderly enabling it to be rolled up easily and
placed on the caddy's handle.
Important: Every two or three cleaning sessions, disconnect the main
14