Dolphin Wave Instrucciones De Uso página 21

Error Message
Robot is stuck on
pool floor
Navigation System
Fuse Fail
No Communication Does the problem
Check
1. Has the robot
stopped on an
obstacle?
2. Is there an
obstruction in the
water channel or in
the robot's driving
belts?
Does the problem
re-occur on every
operation?
Is there an electrical
short or rupture in the
floating cable?
occur when pressing
POOL or HOME on
the MMI?
Action to Take
Move the robot from its position and remove
the obstacle. Reactivate.
If this recurs, contact the Maytronics
dealer/distributor.
Contact the Maytronics dealer/distributor.
Repair cable and replace the fuse.
Note: The fuse holder is located beneath the
power supply on the right hand side.
Replace the fuse with the spare provided.
Note: This is a special fuse and a
replacement can be obtained from your
Maytronics dealer.
Contact the Maytronics dealer/distributor.
Note: You can work temporarily without
using the MMI.
Disconnect it from the power supply thus
disabling the Pool/Home function.
18