Allmand NIGHT-LITE PRO II Manual Del Operario página 21

1. Loosen the tower lock knob (F, Figure 18).
2. Use the handles (G, Figure 18) to rotate the light tower to
the preferred work angle.
3. Tighten the tower lock knob.
To lower the light tower
1. Turn the tower lights off before lowering the light tower.
See Operation - Operating The Tower Lights .
2. Rotate the light tower to the transport position.
a. Loosen the tower lock knob.
b. Use the handles to rotate the tower to the transport
position (light bar 90° (perpendicular) to the trailer
tongue).
c. Tighten the tower lock knob.
3. Turn the winch handle on the light tower counterclockwise
until the telescoping masts are fully lowered.
4. Turn the winch handle on the right side of the unit
clockwise to make sure the lower light tower cable is
taut.
5. Unlock the latch pin at the foot of the light tower.
WARNING
Unsafe Operation Hazard
• Failure to confirm tautness of the lower light tower cable
before unlocking the latch pin could result in death or
serious injury. Be sure the lower light tower cable is taut
before unlocking the latch pin.
6. Turn the winch handle on the right side of the unit
counterclockwise until the light tower is lowered into the
transport (horizontal) position.
WARNING
Tip Hazard
• Failure to fully lower the telescoping masts before
lowering the light tower to the transport position could
result in death or serious injury. Always fully lower the
telescoping masts before lowering the light tower to the
transport position.
7. Secure the light cords into the hook on the rear tower
support.
8. Latch the tower locking pin.
WARNING
Unsafe Operation Hazard
• Failure to lock the light tower in the transport position
with the tower locking pin could result in death or
serious injury. Be sure to lock the light tower in the
transport position with the tower locking pin.
18
Hydraulic (Vertical) Towers
Note: The engine does not need to be running to raise or
lower the light tower.
To raise the light tower
1. Move the tower switch (B, Figure 19) on the control panel
to the UP position to raise the tower (A) to the preferred
height.
To lower the light tower
1. Turn the tower lights off before lowering the light tower.
See Operation - Operating The Tower Lights .
2. Move the tower switch (B, Figure 19) on the control panel
to the DOWN position until the tower (A) is fully lowered.
3. Hold the tower switch in the DOWN position for three
additional seconds, to make sure the tower is fully
lowered.
21