Parametric Equalizer Adjustments - Alpine IVA-W200 Manual De Instrucciones

8
Adjust the G-EQ to your preference.
G-EQ adjustment screen example
Displays the speaker (channel) currently selected
Displays the selected frequency
Displays the frequency level currently selected
Active bar: displays the variable range of the frequency
level currently selected with an orange bar
Setting variable range
Adjusting the Frequency
Touch [ ] or [ ] to adjust the frequency.
Adjusting the Level
Touch [ ] or [ ] to adjust the level.
Creating the Curve Directly
Touching any position in the EQ display moves the active bar to
the touched position. Touching and moving your finger to create
a curve in the EQ display, immediately displays the new curve.
• If LOADING is displayed while [CANCEL] is touched, or an
operation is carried out on the connected audio processor, loading is
stopped and the setting contents (created before stopping) are
displayed.
• Loading time may take longer depending on the setting content. This
is not a malfunction.
9
Touch [RETURN] to return to the previous screen.
• When the speaker is set to the "OFF" mode, the graphic equalizer
for that speaker cannot be set. Refer to "Setting the Speakers"
(page 40).
• Check the playable frequency ranges of the connected speakers
before making the equalizer adjustments. If the speaker's playable
frequency range is 55 Hz to 30 kHz, for example, adjusting the 40 Hz
or 20 Hz band has no effect. Additionally, you may overload and
damage the speakers.
• When graphic EQ is adjusted, the adjustment for parametric EQ
becomes ineffective.

Parametric Equalizer Adjustments

The frequency bands of the graphic equalizer are fixed. This makes it
very difficult to correct for undesired peaks and dips at specific
frequencies. The parametric equalizer's center frequency can be tuned
to these specific frequencies. Then, the bandwidth (Q) and level are
fine-tuned, independently, to make the necessary corrections. The
parametric equalizer function is an advanced tool for serious
audiophiles.
1
Check that Defeat mode is off.
2
Touch [SETUP] on the main source screen.
The SETUP selection screen appears.
3
Touch [i-Personalize].
The i-Personalize screen will appear.
4
Touch [ ] of A.PROCESSOR.
The A.PROC list screen appears.
5
Select L/R or L+R by touching [ ] or [ ] of P-EQ.
Different adjustment values can be set for the left and
L/R:
right channels.
L+R: Sets the same adjustment values for the left and right
channels.
When graphic EQ is adjusted, this setting will be turned off.
6
Touch [ ] of P-EQ.
The P-EQ list screen appears.
7
Touch [ ] of the desired speaker (channel).
The P-EQ adjustment screen appears.
8
Adjust the P-EQ to your preference.
P-EQ adjustment screen example
Displays the speaker (channel) currently selected
Displays the currently selected band
Displays the center frequency of the band currently
selected
Displays the band level currently selected
Displays the bandwidth (Q) of the band currently
selected
Variable range of the center frequency of the selected
band
Active point: displays the position of the center
frequency and level of the band currently selected
Active bar: displayed the variable range of the band
level currently selected
43
-EN