Safety Information - EdilKamin ADRIA Instalación Uso Y Mantenimiento

SAFETY INFORMATION

THE BOILER-STOVE MUST NEVER BE MADE TO
OPERATE WITHOUT WATER IN THE SYSTEM NOR
AT A PRESSURE OF LESS THAN 1 BAR.
IT CAN BE DAMAGED IF IT IS IGNITED WITH NO
WATER IN THE SYSTEM.
• The boiler-stove is designed to heat water by means of
automatic combustion of pellets (wood with 6 mm dia-
meter) in the hearth.
• The only risks that may derive from using the boiler-
stove pertain to non-compliance with the installation
regulations, direct contact with live electrical parts
(internal), contact with the fire or hot parts, or foreign
substances being put into the boiler-stove.
• Should components fail, the boiler-stove is equipped
with safety devices to guarantee its automatic shutdown.
• These are activated without any intervention required.
• In order to function correctly, the boiler-stove must be
installed in accordance with the instructions given
herein.
• Whilst functioning, the door must never be opened. In
fact, combustion is fully automatic and requires no
manual intervention.
• Under no circumstances should any foreign substances
be put into the hearth or the hopper.
• Do not use flammable products to clean the smoke
discharge duct.
• Use a vacuum cleaner to clean the hearth and hopper,
when COLD.
• The glass can be cleaned when COLD with a suitable
product (e.g. GlassKamin) and a cloth. Do not clean
when hot.
• Whilst the boiler-stove is in operation, the exhaust
pipes and door become very hot.
• Do not place anything that is not heat resistant near the
boiler-stove.
• NEVER use liquid fuel to ignite the thermal boiler-
stove or rekindle the embers.
• Do not obstruct the external air inlets in the room where
the boiler-stove is installed, nor those of the boiler-stove
itself.
• Do not wet the thermal boiler-stove and do not go near
electrical parts with wet hands.
• Do not use reducers on the smoke exhaust pipes.
• The boiler-stove must be installed in a room that is sui-
table for fire prevention and equipped with all that is
required (power and air supply and outlets) for the boi-
ler-stove to function correctly and safely.
• The boiler-stove must be kept in a room where the tem-
perature is above 0 °C.
• Use appropriate anti-freeze additives for the water of
the system.
• Ensure that the temperature of the return water is at
least 45 °C.
• Should ignition fail, DO NOT re-ignite until you
have emptied the combustion chamber.
•ATTENTION: THE PELLET EMPTIED FROM THE
COMBUSTION CHAMBER MUST NOT BE DEPOSITED
INSIDE THE HOPPER.
23