Sony UP-DF500 Guía De Utilización página 25

Other Messages
When the following message appears, the ALARM
indicator does not light. The PRINT indicator blinks.
Messages Possible causes and remedies
HEAD IN COOLING The thermal head has overheated.
tLeave the unit until the head has
PLEASE WAIT
cools down and this message
disappears.
HEAD IN HEATING The thermal head is warming up.
tLeave the unit until the head has
PLEASE WAIT
warms up and this message
disappears.
PLEASE WAIT The unit is returning to the initial
settings to restart printing after closing
the covers which opened for removing
jammed film or cleaning.
tLeave the unit until this message
disappears. When this message
appears, the PRINT indicator does
not blink.
Troubleshooting
If Damage is Suspected
If a problem appears, check the following trouble
shooting guide first and perform whatever action is
necessary to solve the problem. If the problem persists,
turn off the printer and consult your Sony dealer.
Symptom Possible causes and remedies
Nothing appears in the • The
LCD. the front panel of the unit is not set
to ON.
tSet the
• The connections may not be
correct.
tMake the connections correctly.
The unit has not The main POWER switch on the rear
turned on even though panel is not set to ON.
ON/STANDBY
tSet the main POWER switch on the
the
switch on the front rear panel to ON.
panel is set to ON.
The unit does not An error message appears on the
print. window display.
tTake the measures recommended in
"Messages". (page 10)
If the Film Jams
If the film jams before printing starts or during printing,
printing stops and the following messages appear on the
LCD.
An error message indicates the position where the film
has jammed. Check the position and follow the steps
below to remove the jammed film.
After the jammed film has been removed, the unit starts
printing if there is image data still to be printed.
• REMOVE FILM TRAY: J0
• REMOVE FILM REAR: J1
• REMOVE FILM REAR & TOP: J2
• REMOVE FILM TOP: J3
• REMOVE FILM TOP & FRONT: J4
• REMOVE FILM FRONT: J5
• REMOVE FILM TOP & INNER: J6
• REMOVE FILM TRAY: J7
• REMOVE FILM SOME PLACES: J8
Notes
• When you put your hands inside of the unit, be careful
not to hurt yourself by touching parts.
• If you turn off the power, image data that has not been
printed yet is cleared.
ON/STANDBY
switch on
ON/STANDBY
switch of the printer to ON.
Troubleshooting
11