Assembly; Delivery Content; Mounting Rip Fence - HOLZMANN MASCHINEN TK 305 Manual De Intrucciones

14

ASSEMBLY

14.1

Delivery content

Please check the product contents immediately after receipt for any eventual transport damage or
missing parts. Claims from transport damage or missing parts must be placed immediately after
initial machine receipt and unpacking before putting the machine into operation. Please understand
that later claims cannot be accepted anymore.
14.2 Assembly
The machine is delivered pre-assembled.
For transport reasons, some parts of the machine can be assembled by the customer.
You can place the machine in the desired location either on a workbench or other recommended
leg set. The base of the saw has four holes to mount the table saw. If the saw is to be used in on
location, permanently fasten it to the workbench or leg set using appropriate bolts with lock
washers and nuts.
When permanently mounting the machine we recommend that the four rubber feet located
underneath each of the mounting holes are removed and stored safely for possible future use.
14.2.1

Mounting rip fence

1. Pull out the "L" shape and
black color stopper of rip
fence.
2. Screw off these two of
dentation columns screw caps.
3. Hold the "Rip fence"; When the
fence "U-shaped slot" with the
small nut of the "Table
orientation plate groupware" in
a straight line, Please insert
the small nut along the U-shaped slot to
"rip fence". ATTENTION: The top hole is
wider than the under hole.
4. Tighten up the dentation columns screw.
5. Resetting the "L" shape and black color
stopper.
6. Insert the assemblies into the "U shape of
the working table face.
7. Adjust 90°
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
ASSEMBLY
38
TK 305