Getting Started - Bresser TempTrend Manual Del Usuario

HOW TO USE THE TABLE STAND
OR WALL MOUNTING
The main unit has a removable table stand, which when
connected, can support the unit on a flat surface. Or you
can remove the stand and mount the unit on a wall using
the recessed screw hole. As for the remote unit, you can
place it on a flat surface or mount the unit on a wall
using the recessed screw hole.

GETTING STARTED

Once batteries are in place for the remote unit, they will
start transmitting temperature readings at around 45
seconds intervals. The main unit will also start searching
for signals for about two minutes once batteries are
installed. Upon successful reception, the outdoors
temperatures will be displayed on the top line and the
indoors temperature on the bottom line. The main unit
will automatically update its readings at about 45-
second intervals.
If no signals are received, blanks " " will be displayed.
Hold [ ] for 2 seconds to enforce another search for
about 2 minutes. This is useful in synchronizing the
transmission and reception of the remote and main units.
Repeat this step whenever you find discrepancies
between the reading shown on the main unit and that
on the remote unit.
HOW TO CHECK REMOTE AND
INDOOR TEMPERATURES
The indoors temperature is shown on the second line of
the display. The outdoors temperature is shown on the top
line of the display.
26