Error Messages And Troubleshooting - Omron M3 Manual De Instrucciones

Ocultar thumbs Ver también para M3:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 42

3. Error Messages and Troubleshooting

If any of the below problems occur during measurement, check to make sure that no other electrical device is within 30 cm. If the problem persists,
please refer to the table below.
Display/Problem
Possible Cause
The [START/STOP] button was pressed
while the arm cuff is not applied.
Air plug is not completely plugged
appears or the
into the monitor.
arm cuff does not
inflate.
The arm cuff is not applied correctly.
Air is leaking from the arm cuff.
You move or talk during a
appears or a
measurement and the arm cuff does
measurement
not inflate sufficiently.
cannot be
Due to the systolic pressure is above
completed after the
210 mmHg, a measurement cannot
arm cuff inflates.
be taken.
The arm cuff is inflated exceeding the
appears
maximum allowable pressure.
You move or talk during a
appears
measurement. Vibrations disrupt a
measurement.
The pulse rate is not detected
appears
correctly.
/
/
appears
does not flash during
a measurement
Solution
Press the [START/STOP] button again to turn the monitor
off. After inserting the air plug securely and applying the
arm cuff correctly, press the [START/STOP] button.
Insert the air plug securely.
Apply the arm cuff correctly, then take another
measurement. Refer to section 5 of instruction manual
Replace the arm cuff to the new one. Refer to section 12
of instruction manual
.
Remain still and do not talk during a measurement. If
"E2" appears repeatedly, inflate the arm cuff manually
until the systolic pressure is 30 to 40 mmHg above your
previous readings. Refer to section 11 of instruction
manual
.
Do not touch the arm cuff and/or bend the air tube while
taking a measurement. If inflating the arm cuff manually,
refer to section 11 of instruction manual
Remain still and do not talk during a measurement.
Apply the arm cuff correctly, then take another
measurement. Refer to section 5 of instruction manual
Remain still and sit correctly during a measurement.
If the "
" symbol continues to appear, we recommend
you to consult with your physician.
EN
.
.
.
EN4

Hide quick links:

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Hem-7154-e

Tabla de contenido