HEM-7322U-E_A_M.book Page 19 Friday, November 8, 2013 1:55 PM
4. Error Messages and Troubleshooting
4.1 Error Messages
Display
Irregular heartbeats are detected.
Movement during measurement.
Arm cuff is applied too loosely.
The batteries are low.
The batteries are exhausted.
Cause
Remove the arm cuff. Wait 2-3 minutes and
then take another measurement.
Repeat the steps in section 3.3. If this error
continues to appear, contact your physician.
Carefully read and repeat the steps in section
3.3.
Apply the arm cuff tighter.
Refer to section 3.1.
You should replace the batteries with new
ones ahead of time.
Refer to section 2.1.
You should replace the batteries with new
ones at once.
Refer to section 2.1.
Solution
EN
19