Maintenance And Lubrication; Implements - Grillo G52 Manual De Uso Y Mantenimiento

MAINTENANCE AND LUBRICATION

LUBRICATION: do the following operations with machine in horizontal position.
N.B.: the oil change must be effected with warmed up machine in order to help the total oil drainage.
ENGINE OIL: Follow the instructions on the «Engine operator's manual» carefully. It is however necessary to
check the oil level every 4 hours taking the plug off (fig. 11 no. 1) and checking that oil reaches the hole border.
Change lubricant the first time after 20 hours. The change it every 50 hours (please refer to relevant engine
handbook).
Unscrew the plug (fig. 11 no. 2).
GEARBOX OIL: check oil level every 50 working hours unscrewing the screw (fig. 1 no. 1). If necessary add some
BLASIA 220 (quantity: 750 gr.) lubricant.
Change oil once per year.
To drain the oil unscrew the plug (fig. 12 no. 1).
MAINTENANCE: after the first working hours, it might be necessary to check and adjust the wheel releasing cable
and the reversing device cable acting on the adjuster situated on the handle (fig. 3). The quick coupling must be
always clean and greased.
To remove the fairing pull upward. The same for the cutter bar conveyor.
Spare parts we recommend to have in stock:
– 1 accelerator cable
– 1 wheel engaging cable
– 1 gas throttle lever
– 5 blade fingers
– 1 complete blade
– 10 cutter bar nails
– 2 cutter bar fingers
– 10 cutter bar finger nails
– 1 right tyne
– 1 left tyne.
HOW TO ORDER SPARE PARTS: address to your area agent or local dealer in your Country. Always give the
machine serial number and part number:
GRILLO S.p.A.
Via Cervese 1701 - 47023 CESENA (FC) ITALY
Tel. 0039 - 0547 - 633.111 / Fax 0039 - 0547 - 632.011
Web site: www.grillospa.it / e-mail: grillo@grillospa.it
END OF SEASON MAINTENANCE
Clean the machine carefully: the air filter, the cutter bar and the rotary tiller.
Change engine and gearbox oil.
Put two wooden boards under the wheels.
I M P L E M E N T S
ROTARY TILLER
The rotary tiller is used to break the superficial layer of the ground so that its permeability is increased and, at the
same time, to rid of weeds (fig. 13).
Tilling depth can be adjusted by lifting or lowering the central knife situated under the rotary unit. To increase depth
it is necessary to lift the knife. It is advisable to start working with the knife in the lowest position and lift it when a
deeper tillage is requested. For a better tillage it is advisable to use the wheel extensions either with cage wheels
or pneumatic wheels.
Important
To protect the machine transmission, the rotary tiller is fitted with two safety screws, which fix the tines in case a
stone or any other foreign object suddenly block the tiller rotation. Should this happen, you have to stop immediately
the engine and to replace the screws, which fix the tines group to the tines shaft. Please use steel screws 1.29.
8