Connecting Main Power Cables - Vetus BOW PRO Serie Instrucciones De Instalación

Main power fuse 2
In the connection unit, there is a main power fuse on the controller.
This fuse must be in place at all times.
When replacing the fuse, the replacement must be of the same rat-
ing.
5.5

Connecting main power cables

Make sure that no other electrical parts come loose when con-
necting the electric cables.
Check all electrical connections after 14 days. Electrical parts
(such as bolts and nuts) may come loose as a result of fluctua-
tions in temperature.
• Take off the cover.
• Feed the battery cables through the input glands in the cover.
• Apply cable terminals to the battery cables and connect the ca-
bles to the motor controller.
The tightening torque of bolts in the motor regulator is a
maximum of 16 Nm.
The drawing shows how the cables must be laid in order for the
cover to be replaced again.
See Chapter 6 Configuring the system before replacing the
cover again
• Reinstall the cover and tighten the glands.
vetus® Installation instructions BOW PRO Series Thrusters: BOWA0651, BOWA0762 and BOWA0902
N
OTE
N
OTE
N
OTE
Make sure that the voltage stated on the motor type plate is iden-
tical to the boat's power supply voltage.
Fuse
Main switch
ENGLISH
N
OTE
14 - 16 Nm
020806.01
29