General Description - GYS WATTMATIC 100 Manual Del Usuario

Translation of the original manual
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
• Equipment in compliance with British requirements. The
British Declaration of Conformity is available on our web-
site (see home page).
• Equipment in conformity with Moroccan standards.
• The declaration C
our website (see cover page).
Disposal:
• This product should be disposed of at an appropriate
recycling facility. Do not dispose of in domestic waste.

GENERAL DESCRIPTION

Congratulations for the selection of this product, which has been designed with great care. To get the best use of it,
please read carefully the following instructions. Keep this instruction manual safe, you may want to read it again later.
WATTMATIC is designed to charge starting liquid or gel electrolyte lead-acid batteries :
- from 15 Ah to 100 Ah in 6V or 12V for the WATTMATIC 100 (3 or 6 2V elements)
- from 20 Ah to 150 Ah in 6V or 12V for the WATTMATIC 140 (3 or 6 2V elements)
- from 25 Ah to 180 Ah in 6V or 12V for the WATTMATIC 170 (3 or 6 2V elements)
Load curve: WUoU. This curve ensures a 100% charge and maintains the level of charge thanks to Floating.
CONNECTION IN CHARGER FUNCTION
Preliminary precautions
• For indoor use, with good ventilation.
• Remove the battery caps if there is, and check the level of liquid. If it is not correct; filled up with distilled water. Clean
well the battery terminals.
• Check if the battery capacity and voltage are compatible with your charger.
Connection and disconnection
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good electric contact, res-
pecting the following order.
▪ Connect first the battery terminal not connected to the chassis of the vehicle.
▪ Then connect the other connection to the chassis remote from the battery and any fuel line.
▪ At last, plug in your charger to 230 V 50/60 Hz mains supply.
▪ Check that the light switches on.
▪ After charging, disconnected the battery charger from mains supply. Then remove the chassis connection and the
battery connection, in this order.
Control of the charge process
• The 2 lights orange and green show the state of the battery charge :
▪ The orange indicator lights when the connection to the battery is done and shows that the charge is in process.
▪ The green indicator lights when the battery is charged.
If the device stays more than 24 h in charge (orange light on), stop the charge (refer to the sulfated battery paragraph).
WATTMATIC 100.140.170
(CMIM) of conformity is available on
‫م‬
EN
9