Possible Combinations; Prerequisites For Installation - Skoda iV Charger Manual De Instrucciones

EN
Your ŠKODA iV Charger Connect+ comes equipped with a kWh meter, and it is compatible
with different types of kWh meters. For example, a 3-phase kWh meter will also be compat-
ible in a 1-phase wallbox, as shown in the following table.

Possible combinations

1-phase ŠKODA iV Charger Connect+
3-phase ŠKODA iV Charger Connect+

4.2 Prerequisites for installation

Danger
Working on electric installations without proper precautions will result in the risk of elec-
tric shock, and thus cause severe injury or death.
▶ The installation must only be performed by qualified electricians.
▶ Make sure that connection of the electrical power cannot occur during installation.
▶ Put up caution tape and warning signs to mark the working areas. Make sure no
unauthorized persons enter the working areas.
Choose location
▶ Position the wallbox, where possible, in surroundings where it is not exposed to
extreme sunlight and vulnerable to external damage.
▶ The wall must have a flat structure and must be able to hold a load of at least 100 kg.
▶ The minimum free space around the wallbox must be a minimum of 300 mm.
Pre-installation checklist
▶ The local installation regulations are identified and are followed.
▶ A miniature circuit breaker (MCB) and residual current device (RCD) must be installed
upstream and have ratings that correspond to the local power supply as well as to the
required charging power.
▶ The following installation instructions are obeyed.
▶ The recommended tools (additional tools needed) are available on site. See chapter
Tools and material needed for more information.
22
1-phase kWh
meter
3-phase kWh
meter