Skoda iV Charger Manual De Instrucciones página 20

▶ The plugs, screws, and drill bits to be used for mounting the wall bracket are suitable
for the wall structure at the place of installation.
▶ The bending radius of the power supply cable is within tolerances during and after
installation.
▶ The bending radius of the charging cable is within tolerances during installation and
storage.
▶ The configuration of the supply cable, Ethernet cable (optional) and CT coils (optional)
is determined.
▶ The Set DIP-switches chapter is consulted for the list of supported CT coils.
▶ A single multi-core cable must be used for connecting multiple CT coils for overload
protection.
NOTE: The above illustration indicates a standard installation height. Observe and comply
with the local accessibility regulations.
300 mm 300 mm
EN
23