Allen-Bradley PanelView 550 Instrucciones De Instalación página 11

8 PanelView 550 Terminals
6. Install the 6 self-locking nuts, hand tight.
7. Alternately tighten the self-locking nuts until the terminal is held firmly
against the panel. Tighten the nuts to a torque of 10 inch-pounds. Do not
overtighten nuts.
ATTENTION
8. Remove the protective installation label covering the top vents of the
terminal.
ATTENTION
Publication 2711-IN009D-MU-P
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Mounting Studs
(3 Top / 3 Bottom)
Protective Installation Label
Self-locking Nuts
(6 used, 8 provided)
Mounting nuts must be tightened to a torque of 10
inch-pounds to provide a proper seal and to prevent
potential damage to the terminal. Allen-Bradley
assumes no responsibility for water or chemical damage
to the terminal or other equipment within the enclosure
because of improper installation.
Failure to remove the protective installation label
covering the top vents could result in overheating and
damage to the terminal.