Allen-Bradley PanelView 550 Instrucciones De Instalación página 15

12 PanelView 550 Terminals
To connect DC power to the PV550 terminal:
1. Secure the DC power wires to the terminal block screws.
2. Secure the Earth Ground wire to the correct terminal block screw.
ATTENTION
ATTENTION
3. Apply 24V dc power to the terminal.
Power Terminal Block (fixed)
+
Publication 2711-IN009D-MU-P
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Explosion Hazard - Do not connect or disconnect
equipment while circuit is live unless area is known to
be non-hazardous.
Do not apply power to the terminal until all wiring
connections have been made. Failure to do so may
result in electrical shock.
Earth Ground
DC Negative
DC Positive