CAME Z Serie Manual De Instrucciones página 23

ENGLISH
After setting the slow down spacing (ref. C fig. 3) with the "adjust microswitches" procedures shown in
the gearmotor's manual...
...take the template - which is supplied with the control panel - and hold it up against one of the two
mechanical stops as shown in fig. 1 ( adjustment is to be made either on the closing endstop or
opening endstop ).
Activate the gate - either using a command button or the remote control - and turn the OP TIME
trimmer clockwise until the gate leaf inverts its direction just as it touches the obstacle/template.
Then turn the template from its short side (fig. 2) and turn the OP TIME trimmer counterclockwise
until the gate leaf stops against the obstable/template.
fig. 1
fig. 2
fig. 3
ADJUSTING THE STOP ZONE
A = Amperometric sensor's operating area with
inverted movement
B = Normal speed operating area
C = Slowdown speed operating area
D = Amperometric sensor's operating area with
stopped movement
E = Closing and opening endstops
OP TIME
OP TIME
-23-