CAME Z Serie Manual De Instrucciones página 5

Accessories which can be connected to
this unit
- "Gate open" signal light (10-5);
- Cycle lamp to light the passage area: it
remains on from the moment the doors begin
to open until they are fully closed (including
the automatic closing time).
closing is not activated, the lamp remains on
only during movement.
- Movement flashing lamp with pre-flashing
option (dip 4 function selector);
- Electric lock ;
- LB18 circuit card for battery operation,
which is automatically connected in case of
power failure. Battery is recharged when line
voltage is restored.
- Radiofrequency AF board (see table
page 28).
An auxiliary contact is also provided on termi-
nals A1-A2 for any device that should be
activated at the same time as the opening
command.
Other functions available
- Automatic closing. The automatic closing
timer is automatically activated at the end of
the opening cycle. The preset, adjustable
automatic closing time is automatically inter-
rupted by the activation of any safety sys-
tem, and is deactivated after a STOP
command or in case of power failure;
- Obstacle detection. When the motor is
stopped (gate is closed, open or half-open
after an emergency stop command), the
transmitter and the control pushbutton will be
deactivated if an obstacle is detected by one
of the safety devices (for example, the pho-
tocells);
- Hammer movement. This feature makes it
easy for the lock to release (the door wings
momentarily press against the closure stops
when the open command is given, which fa-
cilitates release of the electric lock);
- "Operator present" function. Gate operates
only when the pushbutton is held down (the
If automatic
radio remote control system is deactivated);
- Type of command :
- «open-stop-close-stop» for pushbutton
- «open-close-reverse» for pushbutton
- «open only» for radio transmitter.
Adjustments
- Trimmer SENS/VEL = Adjustment of am-
perometric sensitivity during operating: min/
max;
- Trimmer SENS/RALL = Adjustment of am-
perometric sensitivity during slowdown: min/
max;
- Trimmer TCA = Adjustment of automatic
closing time: 1" to 120";
- Trimmer TL = Adjusting of the stop zone
(open/closed position, see page 23);
- Faston connectors on the transformer are
used to select normal operating and slow-
down speeds ;
and disconnect the batteries before
servicing the inside of the unit.
and radio transmitter;
and radio transmitter;
Caution! Shut off the mains power
-5-