Allegion Schlage NDE80 Instrucciones De Instalación Y Guía Del Usuario página 6

Cylinder and Lever Installation
Lever Removal
To remove a lever with a
cylinder, insert key first, and
turn it 90 degrees toward door
edge. Press pin wrench into
hole in lever, and pull off.
Lever With Standard Cylinder
Rotate cam in lever
post until the cam
stops.
Insert cylinder into
lever, then insert key.
Rotate the key as
90˚
shown.
Install lever. Pull end
90
of lever toward you as
you press lever onto
lever post for easier
installation.
Catch pin may need to
be pushed in with pin
wrench for lever to be
installed.
To remove a lever without a
cylinder, press pin wrench into
hole in lever, and pull off.
90˚
LH
90
˚
LH RH
˚
RH
Push
Pull
Lever With Interchangeable Core Cylinder
Install cylinder
tailpiece.
Rotate cam in lever
post until the cam
stops.
Insert key into cylinder
and insert into lever.
Rotate the key
clockwise 15 degrees.
Install lever. Pull end
of lever toward you as
you press lever onto
lever post for easier
installation.
Catch pin may need to
be pushed in with pin
wrench for lever to be
installed.
Non-keyed Lever
Install lever. Pull end of
lever toward you as you
press lever onto lever post
for easier installation.
Catch pin may need to be
pushed in with pin wrench
for lever to be installed.
Check mechanical function of the levers and the cylinder. At this
point, the lock should be in a passage (unlocked) state. When power
is applied, the lock will perform a self test and transition to a secured
(locked) state.
Push
Pull
Push
Pull