Install Batteries - Allegion Schlage NDE80 Instrucciones De Instalación Y Guía Del Usuario

Install Batteries

6
Install batteries into battery holder.
6a Push the tab on the right of the battery securing strap, and
pull out to release battery holder.
6b Install four high-quality alkaline batteries into battery holder.
Follow markings for polarity.
Install only new (4) AA alkaline batteries.
6c Connect cable from battery holder to connector on circuit
board.
CAUTION
Do not allow battery pack to
hang from the wires.
When the batteries are connected, the lock will perform a Power On
Self-Test (POST). The POST is a self-diagnostic test that the lock runs
to verify that the lock is installed correctly. The POST takes
approximately 30 seconds. During the POST, a series of audible beeps
and LED flashes will occur. If no issues are detected, the POST will
conclude with three green flashes of the outside LED and 3 audible
beeps. If the POST detects an issue, the outside LED will flash red 3
times. Once commissioned with the ENGAGE mobile application, any
issues identified during POST can be viewed.
At the completion of the POST the lock will transition to a secured
(locked) state.
6d Snap the battery securing strap into place, then slide the
strap down until snug.
7
Install battery cover screw.
Choose either standard Phillips screw or Torx screw.
8
Install battery cover.
Install battery cover in place, then push up to secure the cover. Tighten
bottom cover screw.
Do not pinch battery cable when installing battery cover.
CAUTION
Removing the battery cover will cause
lock Tamper Mode, which halts
BLE and Wi-Fi communications!
Electrical Ratings (6Vdc, 500mA, 3 W)
Note: The reader activates when it detects the user's hand holding the
credential, so functionality may seem different than a powered wall-
mounted reader.
Screw into
OR center of hole.