Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Quick Installation
The UPS batteries must be fully charged (minimum 24 hours) before plugging
equipment into the unit.
Plug the UPS into an outlet on
1
a dedicated circuit.
NOTE! after plugging the UPS into a live
AC outlet, the UPS (in "Standby" mode)
will automatically charge its batteries,
but will not supply power to its outlets
until it is turned ON.
Plug the equipment into the
2
UPS.*
* The UPS is designed to support only electronic
equipment. If the total VA rating for all
connected equipment exceeds the UPS output
capacity, the UPS will indicate an overload alert.
To find the equipment's VA rating, look on its
nameplate. If the equipment is listed in amps,
multiply the number of amps by 120 to
determine VA. (Example: 1 amp × 120 =
120 VA). To confirm the UPS outlets are not
overloaded, see the LOAD icon description in
the LCD Interface section under Basic
Operation.
Turn the UPS ON.
3
Press and hold the
second. The alarm will beep once briefly.
Mounting (Rack)
Mount the UPS in either a 2-post or 4-post rack or rack enclosure. The user must determine the
fitness of hardware and procedures before mounting. If hardware and procedures are not suitable
for the application, contact the manufacturer of the rack or rack enclosure. The procedures
described in this manual are for common rack and rack enclosure types and may not be
appropriate for all applications.
2-Post Mounting
2-post mounting requires a Tripp Lite 2-Post Rackmount Installation Kit (model: 2POSTRMKITWM,
sold separately).
16-12-138-933440.indb 5
button
for one
A
5
UNSWITCHED
1
UNSWITCHED
2
A
3
LOAD 1
LOAD 2
12/20/2016 2:18:05 PM
Publicidad
Tabla de contenido
