Husky 32220 Instrucciones De Instalación página 10

If the Husky Roller binds or is difficult to move; the housing assemblies may be tilted, this will required
adjusting the shims or 1/2" washers in the cross member. See Figure 11. It may also be due to the base
rails not being parallel. See Figure 1.
If the Husky Roller has too much or too little vertical lift in the housing assemblies; you can adjust the anti-
lift screws on the bottom of the housing assemblies. See Figure 13. To adjust; loosen the lock nut and turn
the set screw with a 3/16" allen wrench. Adjustments should be made in 1/8 turn increments. After
adjustment; tighten the lock nut so that the set screw will not back out on its own. The Husky Roller should
easily roll back and forth. The set screws should be loose enough to not drag on the roller tube, but tight
enough to minimize the lifting of the roller housing.
Roller Tube
Be sure both latch pins MUST fully engage in Holes 4 & 7. See Figures 13 & 14. If not, adjust shims or
1/2" washers so that latch pins fully engage.
All Products limited to Vehicle Tow Rating; see Vehicle Owners Manual. See
for Warranty Information / Tech Support ©2014 Husky Towing Products Revision: June 03, 2014-REV 4
Trouble Shooting
Hole 7
Anti-lift Screws
Latch pins
fully engaged
Figure 14
Page 10 of 42
Figure 13
Vertical Lift
Hole 4
Latch pins NOT
engaged fully
www.huskytow.com