Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
FIG. 1
ASSEMBLY TOOLS REQUIRED - Adjustable Wrench, Rubber Mallet.
ASSEMBLY TIME ESTIMATE - 30 minutes or less.
To reduce the risk of injury, turn unit off and disconnect it from
power source before installing and removing accessories, before adjusting or
when making repairs. An accidental start-up can cause injury.
NOTE: For Model 7814, begin with instruction #5.
1.
Invert the container on a solid, flat surface (like a workbench or floor).
2.
Install the two steering rollers (A, Fig. 2) into the holes provided in the bottom
of the container. Seat firmly.
3.
Insert the wand rest (B, Fig. 2) into its position and seat firmly.
4.
The wheel and axle assembly consists of two wheels on an axle. Place this
assembly in the slot provided in the bottom of the container, and press into
place. Seat firmly. (See Figure 2)
5.
Set container upright, on its wheels.
NOTE: If the vacuum cleaner is to be used to pick-up liquid or wet material,
skip step 6.
6.
Install the paper filter bag. Please note that the mounting hole is offset in the
bag. The hole is closest to the top side of the bag. Position the bag (into the
container), with its top side up, and seat mounting hole onto the container's
intake port. NOTE: Press only on the bag's protective card. Be careful to not
tear the bag.
7.
Place the motor unit onto the container and secure it by closing the two
container locks.
8.
Attach the vacuum hose to the
machine (Fig. 3). The hose is
equipped with a bayonet style
connector. Align the projection on
the side of the hose connector
with the slot in the container intake
port. Slide connector into intake
port and rotate one-quarter turn
clockwise to lock.
9.
Attach the vacuum hose to the
appropriate accessory nozzle or to
the dust port of a power tool.
A
ASSEMBLY
6- ENG
6- ENG
B
A
FIG. 2
FIG. 3
Publicidad
Tabla de contenido
