Operation - Porter Cable 7812 Manual De Instrucciones

The PORTER-CABLE power tool-triggered wet/dry vac is designed for use as a
general purpose shop vacuum, or for use connected to various power tools. With
the dust bag removed, it can be used to pick up water and other wet materials.
A power outlet is provided that allows a power tool to be connected to the vacuum
cleaner. The vacuum cleaner will automatically switch "ON" when the power tool is
started and it will automatically switch "OFF" approximately 6 to 10 seconds after
the power tool is turned "OFF".
POWER SWITCH
The power switch (A, Fig. 4) on both the
7812 and 7814 models is used for the
vacuum cleaner as a stand alone unit.
When not using a power tool, depress
power switch (A, Fig. 4) to begin
vacuuming.
These vacuums can be used to provide a
dust-free environment when attached to a
power tool. An accessory outlet is located
under a hinged cover (B, Fig. 4) on the
front of the vacuum cleaner. Lift this cover
to expose the outlet.
Connect the power cord of the power tool
to outlet (B, Fig. 4), then depress power
switch (A, Fig. 4) on the vacuum cleaner. A
green light, located next to the outlet, will
glow. This light indicates that the vacuum will start automatically when the power
tool is activated.
When the power tool is turned off, the vacuum motor will continue to run for 6 to
10 seconds to finish collecting the dust, and then it will stop.
PARKING BRAKE
Both models are equipped with a parking brake. The parking brake will lock one
wheel to prevent the vacuum from rolling.
To engage parking brake, use your toe to depress the brake button. The brake will
snap into the locked position.
To disengage parking brake, use your toe to pull up on the brake button until it
snaps into the unlocked position.
TOP FILTER
Both models are equipped with a top filter. If vacuum efficiency is reduced
(indicating a clogged filter), proceed as follows:
1. Turn the vacuum cleaner "OFF." Grasp handle (C, Fig. 5) and pull out
[approximately 1.5" (3.8 cm)], then release. Repeat several times. This action
"shakes" the filter to remove loose dirt.
2. Turn the vacuum cleaner "ON" and check performance. If still unsatis-factory,
turn the vacuum cleaner "OFF" and continue to step 3.

OPERATION

A
7- ENG 7- ENG
B
FIG. 4